Radio Engineering Industries Digital BUS-WATCH R4001 Manuel télécharger pdf (Page 22)

Digital BUS-WATCH

PC Software Manual

Radio Engineering Industries, Inc.

640372 - Rev C - 11/10/2009

Page 22 of 75

Rx001 Mobile DVR (Network Connection)

The BUS-WATCH® Play back application can be used to view video currently stored on

an Rx001Mobile DVR through an active network connection between the DVR and the

host PC.

To access video stored on a Rx001 Mobile DVR using the BUS-WATCH® Play back

application, the target DVR network settings must be properly configured, an active

network connection between the host PC and the DVR must exist, and the DVR must be

powered on.

Prior to directly accessing an available network-connected Rx001 Mobile DVR, the

network settings of the target DVR must be properly configured, and a matching entry

must be created using the Device Setup function of the DVR Remote Management

System software. Please see the Rx001 Mobile DVR Hardware Manual for information

on configuring the network settings of the DVR, if necessary. Please see the section

DVR Remote Management System > Setup in this document for details on creating a

matching entry for the target DVR using Device Setup.

A network connection between the Rx001 Mobile DVR and host PC can be established

through a larger network that could potentially include both wired and wireless links.

Please consult your IT administrator for information on establishing a network

connection to the Rx001 Mobile DVR through an existing wired or wireless network.

Alternately, a direct network connection between the host PC and an Rx001 Mobile DVR

can be established by directly connecting a network “crossover” cable between the host

PC Ethernet port and the DVR Ethernet jack. A “crossover” cable is a special type of

network cable that allows two network devices to communicate without the use of a

network switch, hub, or other network infrastructure. Note: A network “crossover” cable

is not included with the Rx001 Mobile DVR, but can be purchased from REI or at

various local and online computer hardware suppliers, if required.

For a direct connection to the DVR, connect the DVR to the host PC Ethernet port using

a crossover cable as shown:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 74 75

Pas de commentaire

Radio Engineering Industries Digital BUS-WATCH R4001 Manuel Page 22