Radio Engineering Industries SD40 Manuel d'utilisateur télécharger pdf (Page 41)

Digital BUS-WATCH

PC Software Manual

Radio Engineering Industries, Inc.

640372 - Rev D - 12/15/2010

Page 41 of 99

company name, vehicle number, or driver/route. In addition, the camera name will be displayed

if the camera name has been populated with a name within Camera Name under the Camera

section within the System Setup of the DVR menu. Clicking again on the Title button will

remove this information. Please refer to the R1001/R4001 Hardware User Manual/Hardware

Installation Manual for more information on this process.

Info Button

The Info Button is used to turn the information box on and off. The information box can also be

turned on with the Map Button, or the Display Button.

BUS-WATCH® Information Box

Additional information from the source DVR of the selected channel is displayed at the bottom

of the viewing area when an extra Window (one more than video channels) window

configuration is selected from the View selection box. This information will also appear when

you hit the Info button.

The BUS-WATCH® Information box is used to display diagnostic data, which occurs as the

video files are being recorded. This data includes status of all the event sensors, the change

Accelerometer x, y and z axis in G force, GPS latitude and longitude coordinates, speed in MPH,

vehicle power in Volts, the date and time of the readings, temperature of the DVR in degrees F,

the company name, vehicle ID, driver name, resolution of the video, frame rate of the video,

firmware version, MCU version and indicators for the ignition and the hard drive heater.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 98 99

Pas de commentaire

Radio Engineering Industries SD40 Manuel d'utilisateur Page 41