Radio Engineering Industries Digital BUS-WATCH Manuel d'utilisateur télécharger pdf (Page 9)

Digital BUS-WATCH

Radio Engineering Industries, Inc.

640289

Rev B -- 11/18/2002

3. Insert the BW Options Harness by snapping it into place.

4. Route the excess harness through the provided hole

5. Assemble the connector box back onto the tower. Observe proper alignment

of connector when inserting into box.

Figure 4

Speedometer Harness

The BUS-WATCH® speedometer input wires are designed to be spliced directly onto

the transmission speedometer transducer wires. In some installations, this may not be

possible (i.e. mechanical speedometer, transmission manufacturer warnings, etc.). The

BUS-WATCH® Vehicle Speed Sensor Kit (P/N 750086) may be required.

Refer to the vehicle service manual for speedometer type, exact wire

location, and transmission manufacturer warnin

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

Pas de commentaire

Radio Engineering Industries Digital BUS-WATCH Manuel d'utilisateur Page 9